

     Field Adjustment Software for the Tektronix TDS 540 Oscilloscope
			   Version 1.4
		 Tektronix Part Number 063-0935-xx

Installing the Program

    To ensure this software will correctly adjust the TDS 540 Oscilloscope,
    be sure to install it using the command "install". The program "install"
    will prompt you for the letter designation of the hard drive on which you
    will install the TDS 540 Adjustment software. It will also prompt you for
    information about your system configuration. You must input this
    information to assure your TDS 540 Adjustment software is correctly
    installed.


Oscilloscope Firmware Version

    This software version supports the Tektronix TDS 540 Oscilloscope
    firmware version "FV:v1.10e" and "FV:v2.09e".

    To see if your oscilloscope has this firmware version, press the
    front panel buttons 'SHIFT' and then 'STATUS' to display the
    oscilloscope information screen.

    If your oscilloscope firmware version is not "FV:v1.10e" or "FV:v2.09e",
    contact your local Tektronix Field Office to verify that this adjustment
    software will work with your oscilloscope.


Program Configuration

    This software procedure is used to adjust a Tektronix TDS 540
    Oscilloscope and is made up of two program files and associated
    system and help files.

    The ADJ540.BAT program file sets up environment variables suitable
    for this procedure and starts the TDS540.EXE program.

    The TDS540.EXE file does the actual adjustment of the oscilloscope
    but is not meant to be run by itself.


How To Run the Adjustment

    To run this adjustment software, at the MS-DOS prompt type:

		ADJ540
